l-1 rev.: 0/2016 www.recom-power.com 3 watt cc/cv single output ac/dc converter features led driver ? 3w class ii ac-dc led power supply ? 350ma, 500ma and 700ma cc/cv output ? fused input and scp, ovp, olp, otp ? 3.75kvac isolation ? ip66 rated ? low cost RACD03-PSE description a compact universal ac input 3w constant current switching power module suitable for driving 1 - 6 high power leds. the output (dual constant voltage / constant current mode) current limit is fxed at 350ma, 500ma or 700ma. at lower output currents, the output is constant voltage. connections are via 118mm long fying leads. selection guide part nom. input cc cv (1) effciency rated number voltage range mode mode typ. power nom./max. (vac) (vdc) (ma) (vdc) (ma) (%) (w) racd03-350-pse 100-120 3-12 350 15 0-300 72 3 / 4.2 racd03-500-pse 100-120 3-9.5 500 none 71 3 / 4.6 racd03-700-pse 100-120 3-4.5 700 6 0-600 62 3 / 3.15 3 y e a r w a r r a n t y 3 basic characteristics parameter condition min. typ. max. input voltage range -10% +10% output voltage range 3vdc 15vdc input current full load, 100vac 110ma input frequency range 47hz 63hz hold-up time 18ms output ripple current 0.1ap-p specifcations (measured at t a = 25c, nominal input voltage, rated load after warm up) all led drivers may not be used without a load. they must be switched on the primary side only. noncompliance may damage the led or reduce its lifetime. constant current (cc) and constant voltage (cv) (1) cv cc cc cv cc racd03-350-pse racd03-500-pse racd03-700-pse nominal current limits output current output voltage 500ma 700ma 600ma 350ma 300ma 0ma 3v 6v 4.5v 11v 9.5v 15v 12v notes: note1: cv mode is approved by recom internal quality standard, but not certifed according ul. j61347-1(h20) certifed j61347-2-13(h21) certifed j55015(h20) certifed
environmental parameter condition value operating temperature range -20c to +40c, ambient max. case temperature . +75c ip rating ip66 operating humidity 5%-85% rh, non condensing design lifetime +25c ambient 20 x 10 3 hours ac/dc converter l-2 rev.: 0/2016 www.recom-power.com specifcations (measured at t a = 25c, nominal input voltage, rated load after warm up) protection parameter condition value input fuse t1a, slow blow short circuit protection (scp) continuous, current limit overload protection (olp) 120% typ. output over voltage protection (ovp) zener diode clamp 350ma 500ma 700ma 17v max. 14v max. 8v max. over temperature protection (otp) shutdown, automatic resatart after cooling down isolation voltage i/p to o/p 3.75kvac / 1 minute derating graph RACD03-PSE series -20 50403020100-10 0 20 40 60 80 100 ambient temperature (c) output current (%) maximum loading of automatic circuit breakers* circuit breaker circuit breaker current typ 10a 16a 20a 25a c 221 247 337 430 * @ 115vac, 1ohm, 90 phase angle and max. load safety and certifications certifcate type (safety) standard safety of control gear for led modules j61347-1(h20) j61347-2-13(h20) emc compliance standard / criterion radio disturbance characteristics of electrical lighting equipment j55015(h20)
l-3 rev.: 0/2016 www.recom-power.com RACD03-PSE series specifcations (measured at t a = 25c, nominal input voltage, rated load after warm up) dimension and physical characteristics parameter value case material plastic package dimension (lxwxh) 52.1 x 29.6 x 23.1mm package weight 45g 4.0 5.0 n l led- led+ pri sec tc 38.1 23.1 61 1721 61 29.6 1281 fc 46.1 52.1 1.30.1 2 mounting screws are included dimensions drawing (mm) connection wired color type strands function 1, white vff 42/0.15 vac in (n) 2, white vff 42/0.15 vac in (l) 3, blue vsf 42/0.15 led- 4, blrown vsf 42/0.15 led+ fc= fxing center tc= case temperature measuring point tolerance: xx.x= 0.5mm xx.xx= 0.35mm connection installation and application led+ led- l n dc/dc converter
ac/dc converter l-4 rev.: 0/2016 www.recom-power.com specifcations (measured at t a = 25c, nominal input voltage, rated load after warm up) RACD03-PSE series the product information and specifcations are subject to change without prior notice. recom products are not authorized for use in safety-critical applications (such as life support) without recoms explicit written consent. a safety-critical application is defned as an application where a failure of a recom product may reasonably be expected to endanger or cause loss of life, infict bodily harm or damage property. the buyer shall indemnify and hold harmless recom, its affliated companies and its representatives against any damage claims in connection with the unauthorized use of recom products in such safety-critical applications. packaging information parameter type value packaging dimension (lxwxh) cardboard box 75.0 x 50.0 x 50.0mm packaging quantity 1pcs storage temperature range -30c to +80c, ambient storage humidity 5%-85% rh, non condensing
|
