performance specifications typ units min max -15 frequency phase noise @ 10 khz offset (1 hz bw) harmonic suppression (2nd) spurious suppression power output load impedance settling time operating temperature range mhz dbc/hz dbc dbc dbm ms c pll-v12c package style 85 -40 0 -70 -2 2 50 3 power supply requirements typ units max 3vdc supply voltage 1: pll (vcc, nom) vdc ma supply voltage 2: vco (vcc, nom) supply current 2: vco (icc, typ) ma 14 supply current 1: pll (icc, typ) 5 25 min basestations mobile radios ? ? ? applications sfs0792c-lf a1 rev application notes ? an-107: manual soldering technique ? an-205: measuring phase noise for sfs series fixed frequency synthesizer surface mount module lfsuffix = rohs compliant. all specificat ions are subject to change without notice. ? z-communications, inc. all rights reserved. 14118 stowe drive, suite b | poway, ca 92064 | tel: (858) 621-2700 | fax: (858) 486-1927 url: www.zcomm.com | email: applications@zcomm.com page 1 of 2 frm-s-002 b note1: phase noise measurement was perfo rmed using a 100mhz reference oscillator with a phase noise of -145dbc/hz @1khz. additional notes reference oscillator signal typ units min max 40 mhz frequency phase noise @1 khz offset dbc/hz -145 -118 792.5 792.5
footprint fixed frequency synthesizer surface mount module sfs0792c-lf a1 rev 0.030 min. cutback from live pads recommended footprint several holes of 0.015 on gnd. plane are recommended for good grounding. o physical dimensions z-comm xxxxxxxx-lf w/o# d/c 6 5 4 3 2 1 7 8 9 10 11 12 note: all dimensions are in inches tol: xxx: +/- 0.010 1 vcc (vco) 3 rf out 5 mux out sfs pin configuration rest ground 6 vcc (chip) 10 ref in 1 vcc (vco) 3 rf out 5 mux out rest ground 6 vcc (chip) 7 clock 8 data 9 enable 10 ref in pva pin configuration 8 n/c phase noise (1 hz bw, typical) offset (hz) (f) (dbc/hz) phase noise, typ. page 2 of 2 frm-s-002 b lfsuffix = rohs compliant. all specificat ions are subject to change without notice. ? z-communications, inc. all rights reserved. url: www.zcomm.com | email: applications@zcomm.com
|
