 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| ZL2004-01 Data Sheet February 18, 2009 FN6847.0 Adaptive Digital DC-DC Controller with Current Sharing Description The ZL2004-01 is specialized version of the ZL2004 DC-DC controller that has been optimized for high output accuracy within a given set of operating conditions. The ZL2004-01 is otherwise identical to the ZL2004 in features and functionality. The ZL2004-01 has been optimized for use with the ZL1505 MOSFET driver and discrete MOSFETs. The ZL2004-01 integrates a proprietary Digital-DC communication bus for current sharing and inter device communication. Adaptive algorithms improve light load efficiency. All operating features can be configured by simple pin-strap selection, resistor selection or through the on-board serial port. The PMBusTM-compliant ZL2004-01 uses the SMBusTM serial interface for communication with other DigitalDC products or a host controller. Features Power Conversion * * * * * * * * * * * * * * * * * Efficient synchronous buck controller 0.2% VOUT set-point accuracy 8.0 V to 10.0 V input range 0.9 V to 1.1 V output range Adaptive performance optimization algorithms Fast load transient response Active current sharing DCR current sensing with digitally adjustable current sense range RoHS compliant (5 x 5 mm) QFN package Digital soft start/stop Precision delay and ramp-up Power good/enable Voltage tracking, sequencing and margining Voltage/current/temperature monitoring SMBus communication (PMBus compliant) Output voltage and current protection Internal non-volatile memory (NVM) Power Management Applications * * * EN PG SS FC ILIM CFG Servers / storage equipment Telecom / datacom equipment Power supplies (memory, DSP, ASIC, FPGA) FLEX V25 VR VDD V (0,1) VMON MGN SYNC DDC POWER MANAGEMENT LDO LEVEL SHIFTER NONVOLATILE MEMORY PWM CONTROLLER PWMH PWML ISENA ISENB CURRENT SENSE TEMP SENSOR SCL SDA SALRT I2 C MONITOR ADC SA (0,1) VSEN+/VTRK XTEMP SGND DGND Figure 1. Block Diagram 1 1-888-INTERSIL or 1-888-468-3774|Intersil (and design) is a registered trademark of Intersil Americas Inc. Copyright (c) Intersil Americas Inc. 2009. All Rights Reserved All other trademarks mentioned are the property of their respective owners ZL2004-01 1. Electrical Characteristics Table 1. Absolute Maximum Ratings Operating beyond these limits may cause permanent damage to the device. Functional operation beyond the Recommended Operating Conditions is not implied. Voltage measured with respect to SGND. Parameter Pin(s) Value Unit DC supply voltage Logic I/O voltage VDD CFG, DDC, EN, FC, FLEX, ILIM, MGN, PG, SA(0,1), SALRT, SCL, SDA, SS, SYNC, VMON, V(0,1) VSEN+, VSEN-, VTRK, XTEMP ISENA, ISENB VR V25 DGND, SGND - - - -0.3 to 17 -0.3 to 6.5 V V Analog input voltages MOSFET drive reference Logic reference Ground voltage differential (VDGND-VSGND) Junction temperature Storage temperature range Lead temperature (soldering, 10 s) -0.3 to 6.5 -1.5 to 6.5 -0.3 to 6.5 -0.3 to 3 -0.3 to +0.3 -55 to 150 -55 to 150 300 V V V V V o o o C C C Table 2. Recommended Operating Conditions and Thermal Information Symbol Parameter Input Supply Voltage Range VDD Output Voltage Range Operating Frequency Operating Ambient Temperature Range Junction to Ambient Thermal Impedance1 Junction to Case Thermal Impedance 2 Min 8.0 0.9 - 0 - - Typ - 1.0 400 - 35 5 Max 10.0 1.1 - 65 - - Unit V V kHz C C/W C/W VOUT FSW TA QJA QJC Notes: 1. JA is measured in free air with the device mounted on a multi-layer FR4 test board and the exposed metal pad soldered to a low impedance ground plane using multiple vias. 2. For JC, the "case" temperature is measured at the center of the exposed metal pad 2 Data Sheet Revision 2/18/2009 www.intersil.com ZL2004-01 Table 3. Electrical Specifications VDD = 8.6 V, VOUT = 1.0 V, TA = 0C to 65C unless otherwise noted. Typical values are at TA = 25C. The following specifications describe the ZL2004-01 electrical specifications that differ from the ZL2004. Please refer to the ZL2004 data sheet for the full operating specification limits for the remaining functions not described herein. Parameter Input and Supply Characteristics IDD supply current at fSW = 400 kHz IDDS shutdown current VR reference output voltage V25 reference output voltage Output Characteristics Output voltage adjustment range Output voltage setpoint accuracy 1 Conditions GH no load, GL no load, MISC_CONFIG[7] = 1 EN = 0 V No I2C/SMBus activity VDD > 6 V, IVR < 50 mA VR > 3 V, IV25 < 50 mA VIN > VOUT VIN = 8.6V, VOUT = 1 V TA = 0 C to + 65 C, ILOAD = 0-40A Min Typ Max Unit - - 4.5 2.25 0.9 - 0.2 16 2 5.2 2.5 - - 30 5 5.5 2.75 1.1 0.2 mA mA V V V % Oscillator and Switching Characteristics SYNC pin floating or NVM configured Switching frequency 2 for 400kHz Switching frequency set-point accuracy Fault Protection Characteristics UVLO threshold range Configurable via I2C/SMBus - -5 2.85 400 - - - 5 16 kHz % V Notes: 1. VOUT set-point measured at the termination of the VSEN+ and VSEN- sense points. 2. The ZL2004-01 has been optimized for operation at 400 kHz only. Please consult the factory for requirements at other operating frequencies. 3 Data Sheet Revision 2/18/2009 www.intersil.com ZL2004-01 2. Ordering Information 4 Data Sheet Revision 2/18/2009 www.intersil.com ZL2004-01 3. Revision History Rev. # Description Date 1.0 1.1 Data sheet initial release Updated Ordering Information March 2008 May 2008 February 2009 Assigned file number FN6847 to datasheet as this will be the first release with an Intersil file number. Replaced header and footer with Intersil header and footer. FN6847.0 Updated disclaimer information to read "Intersil and it's subsidiaries including Zilker Labs, Inc." No changes to datasheet content 5 Data Sheet Revision 2/18/2009 www.intersil.com ZL2004-01 Zilker Labs, Inc. 4301 Westbank Drive Building A-100 Austin, TX 78746 Tel: 512-382-8300 Fax: 512-382-8329 (c) 2008, Zilker Labs, Inc. All rights reserved. Zilker Labs, Digital-DC, and the Zilker Labs Logo are trademarks of Zilker Labs, Inc. All other products or brand names mentioned herein are trademarks of their respective holders. This document contains information on a product under development. Specifications are subject to change without notice. Pricing, specifications and availability are subject to change without notice. Please see www.zilkerlabs.com for updated information. This product is not intended for use in connection with any high-risk activity, including without limitation, air travel, life critical medical operations, nuclear facilities or equipment, or the like. The reference designs contained in this document are for reference and example purposes only. THE REFERENCE DESIGNS ARE PROVIDED "AS IS" AND "WITH ALL FAULTS" AND INTERSIL CORPORATION AND IT'S SUBSIDIARIES INCLUDING ZILKER LABS, INC. DISCLAIMS ALL WARRANTIES, WHETHER EXPRESS OR IMPLIED. ZILKER LABS SHALL NOT BE LIABLE FOR ANY DAMAGES, WHETHER DIRECT, INDIRECT, CONSEQUENTIAL (INCLUDING LOSS OF PROFITS), OR OTHERWISE, RESULTING FROM THE REFERENCE DESIGNS OR ANY USE THEREOF. Any use of such reference designs is at your own risk and you agree to indemnify Intersil Corporation and it's subsidiaries including Zilker Labs, Inc. for any damages resulting from such use. 6 Data Sheet Revision 2/18/2009 www.intersil.com |
Price & Availability of ZL2004-01
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |