 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM PRODUCT D AT A SHEET CRYSTAL CONTROLLED OSCILLATORS 3.3V SURFACE MOUNT VCSO OSCILLATOR ABSOLUTE M AXIMUM RATING S PARAMETER Storage Temperature Supply Voltage Control Voltage (Vcc) (Vc) UNITS MINIMUM -55 -0.5 -0.5 NOMINAL MAXIMUM 125 7.0 7.0 UNITS C Vdc Vdc TABLE 2.0 MINIMUM (Fo) NOMINAL 622.08 +/-150 3.3 -70 -105 -145 -155 MAXIMUM UNITS MHz ppm C Vdc mA ps rms ps rms dBc/Hz dBc/Hz dBc/Hz dBc/Hz 1 NOTE TABLE 1.0 NOTE CW 0639 VSPLD63TE 622.08M VSPLD63TE DESCRIPTION OPERATING SPECIFIC ATIONS PARAMETER Center Frequency Frequency Stability Operating Temperature Range Supply Voltage Supply Current Jitter (BW=10Hz to 20MHz) Jitter (BW=12kHz to 80MHz) SSB Phase Noise at 100Hz offset SSB Phase Noise at 1KHz offset SSB Phase Noise at 10KHz offset SSB Phase Noise at 100KHz offset (Vcc) (Icc) -40 3.135 - 85 3.465 80 3.0 0.5 - The Connor-Winfield VSPLD63TE is a 3.3V Voltage Controlled SAW Oscillator (VCSO) with Differential LVPECL outputs and Enable/Disable function. The VSPLD63TE is designed for use with PLL systems in SONET/SDH systems requiring low jitter and wide pull range over the industrial temperature range. No multiplication schemes are used in this oscillator design. FEATURES VOLTAGE CONTROLLED SAW OSCILLATOR LOW PROFILE, SURFACE MOUNT PACKAGE 3.3V OPERATION INPUT CHARACTERISTICS PARAMETER Control Voltage Range Absolute Pull Range (APR) Gain Transfer (Kv) Monotonic Linearity Input Impedance Modulation Bandwidth (3dB) Enable Input Voltage (Low) Disable Input Voltage (High) (Vil) (Vih) (Vc) MINIMUM 0.3 +/-50 -15 10 2.275 NOMINAL 1.65 175 50K MAXIMUM 3.0 15 1.68 UNITS Vdc ppm ppm/volt % Ohm KHz Vdc Vdc TABLE 3.0 NOTE 2 - 3 3 TABLE 4.0 LOW JITTER <0.5pS RMS ABSOLUTE PULL RANGE (APR): 50ppm LOW VOLTAGE PECL OUTPUT CHARACTERISTICS PARAMETER LOAD Voltage (High) (Low) Duty Cycle at 50% Level Rise and fall times (Measured 20% to 80%) (Voh) (Vol) MINIMUM 2.275 45 NOMINAL 50 250 MAXIMUM 50 1.68 55 400 UNITS Ohms Vdc Vdc % ps NOTE 4 TEMPERATURE RANGE: -40 to 85C DIFFERENTIAL LVPECL OUTPUTS ENABLE / DISABLE FUNCTION TAPE AND REEL PACKAGING RoHS 5/6 COMPLIANT PACKAG E CHARACTERISTICS Package TABLE 5.0 Non-hermetic package consisting of an FR4 substrate with grounded metal cover. TABLE 6.0 See solder profile page 2. Ultrasonic cleaning is not recommended. PROCESS RECOMMENDATIONS Soldering Process Wash Notes 1.0 2.0 3.0 4.0 ORDERING INFORMATION VSPLD63TE - 622.08MHz VCSO SERIES CENTER FREQUENCY I Frequency stability vs. change in temperature, control voltage (Vc) = 1.65 Vdc. Control voltage for (Fo) = 1.65 Vdc Typical. Positive Transfer Function. When oscillator is disabled the pin 4 output is in a low state (Vol) and the pin 5 output is in the high state (VoH) 50 ohm termination into Vcc-2V or Thevein equivalent. Specifications subject to change without notice. DATA SHEET #: Vs001 PAGE 1 OF 2 REV: 01 DATE: 9/29/06 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. WWW.CONWIN.COM PRODUCT D AT A SHEET CRYSTAL CONTROLLED OSCILLATORS Package Outline .140 MAX (3.56mm) Pin Connections TABLE 7.0 Function Control Voltage Enable / Disable Ground (Case) Output Q Output Q Vcc CW VSPLD63TE 622.08M Pin 1 2 3 4 5 6 Dimensional Tolerance: .005 (.127mm) Output Waveform Suggested Pad Layout Test Circuit Temperature 225C 183C 150C 100C Solder Profile Ramp-Up Rate 3C/second max. from 150C to 225C. Ramp-Down Rate 6C/second max. 225C tp 2 25C 1.65V 0 60-120s Max. 360 Sec. Max. 10-30s 60-150s Max. E/D Time Vcc = Vcc2 = 3.3Vdc Specifications subject to change without notice. DATA SHEET #: Vs001 PAGE 2 OF 2 REV: 01 DATE: 9/29/06 aCopyright 2001 Connor-Winfield all rights reserved. |
Price & Availability of VSPLD63TE
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |