...LED pulses at a 1.0 Hz rate. In remote smoke, the LED is inhibited as well. An active guard is provided on both pins adjacent to the detect ...local Smoke condition activates a current limited output driver, thereby signaling remote Smoke to i...
Description
LONIZATION SMOKE DETECTOR IC WITH INTERCONNECT AND TEMPORAL HORN DRIVER 电离烟雾报警器集成电路互连和颞角驱动
...sed as encoder/decoder pairs in remote control applications. The MC145026 encodes nine lines of information and serially sends this informat...local address. Second, the 4 bits of data must match the last valid data received. The active VT ind...
...c Noise and Battery Consumption remote Temperature Measurement Accurate to 1 C Using remote Diode 0.125 C Resolution on remote Temperature Channel local Temperature Sensor with 0.25 C Resolution Pulsewidth Modulation Fan Control (PWM) Progr...
Description
Complete, ACPI Compliant C remote Thermal Monitor with Integrated Fan Controller Intelligent Temperature Monitor and PWM Fan Controller
...c Noise and Battery Consumption remote Temperature Measurement Accurate to 1 C Using remote Diode (Two Channels) 0.125 C Resolution on External Temperature Channels local Temperature Sensor with 0.25 C Resolution Pulsewidth Modulation Fan C...
Description
Complete, ACPI Compliant, Dual Channel C remote Thermal Monitor with Integrated Fan Controller for two Independent Fans, Pin Compatible with the ADM1030 Intelligent Temperature Monitor and Dual PWM Fan Controller
remote Temperature Sensing Offset Registers for System Calibration 0.125 C Resolution/1 C Accuracy on remote Channel 1 C Resolution/3 C Accuracy on local Channel Fast (Up to 64 Measurements per Second) 2-Wire SMBus Serial Interface Supports...
remote temperature channels 1C accuracy on local and remote channels Automatic remote temperature channels, up to 1 k Fast (up to 64 measurements per second) SMBus 2.0, 1.1, and 1.0 compliant SMBus address input/LOCATION input to UDID Progr...
Description
Thermal Monitor and Fan Speed Controller Thermal Monitor and Fan Speed (RPM) Controller
...ircuit as been established with remote equipment. DATA TERMINAL READY: The DTR pin can be set (low) by writing a logic 1 to MCR(0), Modem Co...local loopback feature for diagnostic testing of the 62C50A. When MCR(4) is set high,
8
82C50A...
Description
From old datasheet system CMOS Asynchronous Communications Element